­
Probing into the Key Aspects of Hot Water System Installation - Intriguing Aussie Portal -->

Probing into the Key Aspects of Hot Water System Installation

by - January 28, 2019

Do you like to bath in cold water in winter? The answer will be no! Nowadays homeowners are spending money on installation of a hot water system in their homes to get rid of the continuous flow of hot water in their homes. You should know that you cannot install a hot water system by your own so you can contact the dealer with whom you are purchasing the system so that he can send a professional expert. 

You will require the support of the professional who excels in hot water system installation because it involves a clear understanding of the existing plumbing system along with the knowledge of the rules and regulations that governs such installation. To make sure that everything goes according to the plan and your hot water system works just as desired, you will need to know and follow a few key aspects that are essentially required while installing such systems in your home or office.

Understanding the anatomy is another key aspect in hot water system installation whether it comes with a storage tank or a modern tankless system. This will ensure that it is installed and used in the right manner. It will also help you to take good care of the basic operation so that the system provides you with relief for a long time.

Hot-Water-System-Installation
Hot-Water-System-Installation

The Steps to Follow

There is a specific process to follow during hot water system installation.
  • Shut off the main water supply valve and the gas to the water heater. With a quarter turn of the shutoff valve, the handle should be at a right angle to the pipe. Make sure you open a faucet at the lowest floor to drain the lines.
  • Drain the water in the tank by attaching a garden hose. Take proper precautionary measures as the water will be scalding hot.
  • Cut off the water lines by unscrewing the vent pipe from the vent hood. Move it and cut the hot and cold-water lines using a tube cutter.
  • Attach the new temperature and pressure relief valve and a copper discharge pipe with Teflon tape and screw it tightly.
  • Attach all pipe assemblies to the hot water outlet and cold-water inlet ports at the top of the tank. Use short plastic lined nipples to protect against galvanic corrosion, or if you have hard water or if the local codes require it.
To finish the hot water system installation, attach the water lines; reattach the vent and the gas lines. In the end, check for any back drafting as most systems will have a natural draft to draw the combustion fumes up the flue. Check for leaks and bubbles at connections and then light the pilot. 

Hot Water System Installation
Hot Water System Installation
The Need of a Pro

Knowing about the process now, you may think whether or not you will need to hire a professional for hot water system installation. Ideally, for safe and effective installation you will need to hire both a professional plumber as well as a qualified electrician.

Even if you have a gas or a solar hot water system with a gas booster, you will need to get such professionals for the installation job. They will know the requirements as per the state code because the federal government is currently endeavoring to phase out electrical hot water systems especially in those areas where you get natural gas easily.

The most significant reason to hire a professional plumber for hot water system installation is for warranty and safety. Most manufacturers will consider the terms of the warranty as void if you do not install the system by a professional plumber. Therefore, it is wise to be safe and hire a professional plumber. 

You May Also Like

0 comments

Note: only a member of this blog may post a comment.